News Release

2016-02-15
Weltrend’s USB Power Delivery Controllers Achieve USB-IF Certification

Weltrend Semiconductor announced that its USB Power Delivery (PD) controller chipsets passed the USB Implementers Forum (USB-IF) certification test for USB-Type-CTM DFP (Downstream Facing Port) applications. The Weltrend controllers passed the full set of compliance tests at the recently held USB-IF Compliance Workshop event in Taipei, Taiwan.


Weltrend’s USB PD controllers address a broad set of market segments for the emerging USB Type-C products including power adapters for USB Type-C based notebooks, 2-in-1s, tablets, and smartphones as well as USB Type-C based accessories such as docking stations and dongles.


The Weltrend USB PD controllers are high-voltage process based and are highly integrated to minimize external components. The controllers integrate USB-PD baseband PHY, Type-C cable detection, shunt regulator, voltage and current monitors, discharge port, MCU and control circuit of blocking MOSFET.
An embedded programmable memory is available for program code and user configuration data. An on-chip regulator can operate at single power supply from 4V to 30V.

 

Key features of Weltrend’s USB PD controllers include:
● USB Type-C charge-only Downstream Facing Port (DFP)
● USB Type-C Upstream Facing Port (UFP) for dongle applications.
● USB Power Delivery Specification Rev. 2.0
● USB Type-C Cable and Connector Specification Revision 1.1
● Built-in shunt regulator and support 5V to 20V VBUS output
● Programmable Over Voltage Protection (OVP) and Over Current Protection (OCP)
● Low side voltage output current shunt monitor
● CPU equipped with program memory and SRAM for the implementation of following features:
  -Power Delivery message protocol and device policy
  -VBUS output voltage control
  -Power supply protection
● External blocking MOSFET control
● Internal RC oscillator
● Internal VDD regulator
● General purpose I/Os
● Serial interface: I2C and UART
● Support power saving mode
● Operating voltage range: 4V ~ 30V
● Operating temperature range: -20°C ~ +105°C

 

More information please refer to http://www.weltrend.com.tw/en-global/news/detail/174/30 , or contact Mr. Bruce Liao at Seraphim, Tel:+886-226984540 ext. 245 or email bruceliao@seraphim.com.tw



Previous Page   |   Back   |   Next Page